Barco ImagePRO-II User Manual page 116

5. Web Remote Control Operations
Backing Up and Restoring Data with the Web Interface
On this and the other tabs, you also can monitor the Field Programmable Gate Array
(FPGA) temperature.
_~ÅâáåÖ=ré=~åÇ=oÉëíçêáåÖ=a~í~=ïáíÜ=íÜÉ=tÉÄ=fåíÉêÑ~ÅÉ
You can back up two types of ImagePRO-II files using the Web Interface — system
configurations and logos. The system configuration consists of any custom settings that
you create for the ImagePRO-II. A logo is a stored image that you capture from the
ImagePRO-II. You can download these files to a computer, then restore them for later
reuse.
_~ÅâáåÖ=ré=a~í~=ïáíÜ=íÜÉ=tÉÄ=fåíÉêÑ~ÅÉ

To save the current system configuration, use the following procedure:
1.
102
On this page, you can:
~ View the ImagePRO-II's current firmware version, on the Build Info line.
~ View the firmware release number, on the Build line.
~ See at a glance when a new firmware version is available, and use the
Auto Upgrade feature to install it.
~ Use the Upload Firmware feature to upload a different firmware version.
For more information about the Auto Upgrade and Upload Firmware
features, refer to the
section on page 170, in Appendix C.
Because smartphones and tablets limit the file types that you
Note
can upload, you cannot back up configuration files to these
devices.
On the Folsom ImagePRO-II page, select the Settings Backup and Restore
tab. The page that appears provides two sets of options, one for backing up and
restoring the current system configuration, and one for managing logos.
Upgrading Firmware Using the Web Interface
ImagePRO-II • User's Guide