Barco ImagePRO-II User Manual page 43

4. Menu Orientation
j~âáåÖ=~=jÉåì=pÉäÉÅíáçå
To select a menu item, use the ADJUST knob to scroll to the item, then press the SEL
button on the front panel:
•
•
•
bñáíáåÖ=~=jÉåì
•
•
^åëïÉêáåÖ=~=jÉåì=nìÉêó
The SEL button is used to answer Yes to certain menu queries. The ESC button is used to
answer No to menu queries. The following illustration shows an example of a menu query.
Save Input Config?
<SEL> = Yes
<ESC> = No
Figure 4-6. Save Input Configuration Query
ImagePRO-II • User's Guide
To scroll through a menu:
~ Turn the ADJUST knob counter-clockwise to scroll down.
~ Turn the ADJUST knob clockwise to scroll up.
To open a submenu, scroll to the submenu line and press SEL.
Throughout this user's guide, the term "select" is used as an
Note
abbreviation for "scroll to a menu line and press SEL."
To change a parameter, scroll to the desired line and press SEL. The navigation
cursor changes to the edit cursor. Use the ADJUST knob to modify the value:
~ Turn the ADJUST knob clockwise to increase a value.
~ Turn the ADJUST knob counter-clockwise to decrease a value.
Then press SEL to accept a parameter or value. The edit cursor changes back to
the navigation cursor.
You must press SEL to accept the value.
Note
In the edit mode (i.e., the edit cursor is visible), press ESC to exit a menu without
changing the original parameter.
To navigate back up the menu structure, press ESC again. Each press takes you
back up the menu tree by one level.

Example: Select the Input menu to begin
configuring inputs.
Using the Menu System
29