Sbus:uart:base - Agilent Technologies InfiniiVision 5000 Series Programmer's Manual

5
Commands by Subsystem

:SBUS:UART:BASE

Command Syntax
:SBUS:UART:BASE <base>
<base> ::= {ASCii | BINary | HEX}
The :SBUS:UART:BASE command determines the base to use for the UART
decode display.
This command is only valid on 4 (analog) channel oscilloscope models when the
N O T E
UART/RS-232 triggering and serial decode option (Option 232) has been licensed.
Query Syntax
:SBUS:UART:BASE?
The :SBUS:UART:BASE? query returns the current UART decode base
setting.
Return Format
<base><NL>
<base> ::= {ASCii | BINary | HEX}
Errors
•
See Also •
•
328
(see page 586)
"- 241, Hardware missing"
"Introduction to :SBUS Commands"
":TRIGger:UART Commands"
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
on page 547
on page 317
on page 428