Installing Additional Drive Enclosures; Installable Drive Enclosures; Drive Enclosure Handling Instructions - Fujitsu ETERNUS DX60 S3 Operating Instructions Manual

Chapter 4 Component Expansion/Function Enhancement
4.2

Installing Additional Drive Enclosures

4.2 Installing Additional Drive Enclosures
Drive enclosures can be installed while the ETERNUS DX is running without affecting the system.
This section explains how to install drive enclosures in the ETERNUS DX.
4.2.1

Installable Drive Enclosures

For installable drive enclosures, refer to "Product List".
4.2.2

Drive Enclosure Handling Instructions

■
About Condensation
Do Not
Do not uninstall or move a drive enclosure that is already installed.
•
Contact your sales representative or maintenance engineer if a drive enclosure
needs to be uninstalled or moved.
Do
When installing the ETERNUS DX, secure the rack to the floor to prevent the rack
•
from moving out of place or from toppling over. For details on the rack installation
requirements, refer to "Site Planning Guide".
Do
When moving a drive enclosure from a cold place, such as an unconditioned store
•
house in winter, to a warmer place such as an air-conditioned room, the severe
temperature change may result in condensation forming.
To avoid this, allow the packed drive enclosure sufficient time in the warmer place
(one hour for each 15°C of temperature difference) to adapt to the new tempera-
ture.
FUJITSU Storage ETERNUS DX60 S3 Disk storage system Operation Guide (Basic)
Copyright 2014 FUJITSU LIMITED
51
P3AM-9012-01ENZ0