Chapter 5 Installing Optional Products
5.2 Installing Drive Enclosures
6
7
8
9
10
5.2
Installing Drive Enclosures
Optional drive enclosures can be installed while the ETERNUS DX Disk storage system is run-
ning without affecting the system.
This section explains how to install optional drive enclosures.
5.2.1
Installation Rules for Drive Enclosures
Only one drive enclosure can be connected to a 3.5" type controller enclosure.
Drive enclosures cannot be connected to 2.5" type controller enclosures.
5.2.2
Installable Drive Enclosures
Table 5.3
Table 5.3
ETEED1DU-L, FTS:ETEED1DU-L
ETEED2DU-L, FTS:ETEED2DU-L
At time of purchase, the installable drive enclosure model may be different from those described.
To find the web-site to check the latest version of this manual, refer to "Read Me First".
ETERNUS DX60 S2 Disk storage system User's Guide -Operation-
Repeat
Step 4
and
Step 5
Remove the wrist strap.
Remove the front cover.
For details on how to attach the front cover, refer to
Front Cover" (page
36).
On the Storage System Status screen of ETERNUS Web GUI, check that the
added disks have been recognized.
Set up RAID groups, volumes, hot spares, and Host Affinity settings on the new
disks, as required.
shows the installable drive enclosures.
Installable drive enclosures
Model name
Copyright 2011 FUJITSU LIMITED
for each additional disk.
"2.3 Attaching and Removing the
Product name
Drive enclosure for DX60 S2 (3.5inch, single-expander type)
Drive enclosure for DX60 S2 (3.5inch, dual-expander type)
63
End of procedure
P3AM-5512-02ENZ0