(Save Or Update The Flash Bios Or Fcode) - Qlogic 2400 Series User Manual

5–Fibre Channel Noninteractive Commands
-b (Save or Update the Flash BIOS or FCode)
QConvergeConsole CLI toggles the LED's state. If the LED is flashing, the
flashing stops. If the LED is not flashing, the flashing begins.
If QConvergeConsole CLI is not in silent mode (see
page 5-33), one of the following messages appears to indicate the LED's current
state:
The LED Flashing for <hba instance> <hba wwpn> has been turned ON
The LED Flashing for <hba instance> <hba wwpn> has been turned OFF
The hba instance and hba wwpn variables must match the command input
parameter.
-b

(Save or Update the Flash BIOS or FCode)

Use the -b command to:

Update the BIOS or FCode from a file (1).

Save the BIOS or FCode to a file (2).
To update one or all adapter's Flash with new BIOS or FCode, issue the following
command:
# qaucli -pr fc -b (all | <hba instance> | <hba wwpn>) [(<-rg> |
all)] <BIOS/FCode File Name>
Where:
BIOS/FCode File
a
Region update only supported on QLA/QLE/QMC246x adapters.
To save the BIOS or FCode to a file, issue the following command:
# qaucli -pr fc -b (<hba instance> | <hba wwpn>) SAVE <BIOS/FCode
File Name>
5-6
all = All adapters of the same type in the system are updated with
the new BIOS/FCode
hba instance = Adapter number (use -g command to find)
hba wwpn = World wide port name
-rg = Flash region update mode (4GB adapters only
all = Update all regions (BIOS/FCode/EFI) depending on the Flash
= Name or path of file continuing update BIOS/FCode
Name
"-s (Silent Mode)" on
a
)
SN0054667-00 B