Subsequent Update Installation; Starting The Qlogic Adapter Cim Provider - Qlogic 8200 Series User Manual

1–Product Overview
Installing the QLogic Adapter vCenter Plug-in for ESX/ESXi
3. Issue the vihostupdate command to install the offline bundle as follows:
# vihostupdate.pl <conn_options> --install --bundle
offline-bundle.zip --nosigcheck
For available options, refer to the vihostupdate page.
4. Follow the on-screen instructions to complete the installation. You may need
to reboot the ESXi system.
NOTE:
For more details on vihostupdate, refer to the documents on the VMware
vSphere Command-Line Interface Documentation page, located here:
http://www.vmware.com/support/developer/vcli/

Subsequent Update Installation

To update the QLogic Adapter CIM Provider after a prior VIB installation:
1. Follow the instructions in the
section to remove the existing VIB.
2. Follow the instructions in the

Starting the QLogic Adapter CIM Provider

After a system startup, the Small Footprint CIM Broker (SFCB) CIM object
manager (CIMOM) in the ESX system should start automatically and load the
QLogic Adapter CIM Provider when necessary.
For ESX systems, you can also manually stop, start, or restart the SFCB CIMOM
by issuing the following commands.
To stop the SFCB CIMOM and the QLogic Adapter CIM Provider:
# /etc/init.d/sfcbd-watchdog stop
To start the SFCB CIMOM and the QLogic Adapter CIM Provider:
# /etc/init.d/sfcbd-watchdog start
To restart the SFCB CIMOM and the QLogic Adapter CIM Provider:
# /etc/init.d/sfcbd-watchdog restart
After starting the SFCB CIMOM, use a CIM client utility to query the QLogic
Adapter CIM Provider for information.
1-16
Removing the QLogic Adapter CIM Provider
Initial Installation section to install the new VIB.
SN0054671-00 A