Diagnostic Test Descriptions - Qlogic FastLinQ 3400 Series User Manual

17–User Diagnostics in DOS

Diagnostic Test Descriptions

Command
Options
uediag -mfw
<1/0>
uediag -t
<groups/tests>
uediag -T
<groups/tests>
uediag -ver
Diagnostic Test Descriptions
The diagnostic tests are divided into four groups: Basic Functional Tests (Group
A), Memory Tests (Group B), Block Tests (Group C), and Ethernet Traffic Tests
(Group D). The diagnostic tests are listed and described in
Number
Group A: Basic Functional Tests
A1
A2
A3
Table 17-1. uediag Command Options (Continued)
Enables/disables management firmware.
1 = Enable
0 = Disable
Disables certain groups/tests.
Enables certain groups/tests.
Displays the version of QLogic 8400/3400 Series User Diagnos-
tics (uediag) and all installed adapters.
Table 17-2. Diagnostic Tests
Test
Name
Register Verifies that registers accessible through the PCI/PCIe
interface implement the expected read-only or
read/write attributes by attempting to modify those reg-
isters.
PCI Configura- Checks the PCI Base Address Register (BAR) by vary-
tion ing the amount of memory requested by the BAR and
verifying that the BAR actually requests the correct
amount of memory (without actually mapping the BAR
into system memory). Refer to PCI or PCI-E specifica-
tions for details on the BAR and its addressing space.
Interrupt Generates a PCI interrupt and verifies that the system
receives the interrupt and invokes the correct ISR. A
n2egative test is also performed to verify that a masked
interrupt does not invoke the ISR.
242
Description
Table 17-2.
Description
83840-546-00 E