Advertisement
Command Mode
Global Configuration mode
User Guidelines
•
To specify multiple hosts, multiple radius-server host commands can be used.
•
If no host-specific timeout, retransmit, deadtime or key values are specified, the global values
apply to each host.
•
The address type of the source parameter must be the same as the ip-address parameter.
•
Up to 4 RADIUS servers can be defined.
Example
The following example specifies a RADIUS server host with the following characteristics:
•
Server host IP address — 192.168.10.1
•
Authentication port number — 20
•
Timeout period — 20 seconds
console(config)# radius-server host 192.168.10.1 auth-port 20
timeout 20
radius-server key
The radius-server key Global Configuration mode command sets the authentication and
encryption key for all RADIUS communications between the Ethernet Switch Module and the
RADIUS daemon. To reset to the default, use the no form of this command.
Syntax
radius-server key [key-string]
no radius-server key
•
key-string — Specifies the authentication and encryption key for all RADIUS
communications between the Ethernet Switch Module and the RADIUS server. This key
must match the encryption used on the RADIUS daemon. The key can be up to 128
characters long.
Default Configuration
The default is an empty string.
Command Mode
Global Configuration mode
198
Radius Commands
Advertisement
