bridge multicast forward-all
The bridge multicast forward-all Interface Configuration (VLAN) mode command enables
forwarding of all multicast packets on a port. To restore the default, use the no form of the bridge
multicast forward-all command.
Syntax
bridge multicast forward-all {add | remove} {ethernet interface-list | port-channel port-
channel-number-list}
no bridge multicast forward-all
•
add — Adds ports to the group.
•
remove — Removes ports from the group.
•
interface-list — Separate non-consecutive valid Ethernet ports with a comma and no
spaces; a hyphen is used to designate a range of ports.
•
port-channel-number-list — Separate non-consecutive valid port-channels with a comma
and no spaces; a hyphen is used to designate a range of port-channels.
Default Configuration
Forward-all is not defined on any interface.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
There are no user guidelines for this command.
Example
In this example all multicast packets are forwarded to port g16.
console(config)# interface vlan 2
console(config-if)# bridge multicast forward-all add ethernet
g16
bridge multicast forbidden forward-all
The bridge multicast forbidden forward-all Interface Configuration (VLAN) mode command
forbids a port to be a forward-all-multicast port. To restore the default, use the no form of the
bridge multicast forward-all command.
Address Table Commands
61