Advertisement
When starting a session, the initial mode is the User EXEC mode. Only a limited subset of
commands are available in User EXEC Mode. This level is reserved for tasks that do not change the
configuration. To enter the next level, the Privileged EXEC mode, a password is required.
The Privileged mode gives access to commands that are restricted on EXEC mode and provides
access to the Ethernet Switch Module Configuration mode.
The Global Configuration mode manages the Ethernet Switch Module configuration on a global
level.
The Interface Configuration mode configures specific interfaces in the Ethernet Switch Module.
User EXEC Mode
After logging into the Ethernet Switch Module, the user is automatically in User EXEC command
mode unless the user is defined as a privileged user. In general, the User EXEC commands allow
the user to perform basic tests, and list system information.
The user-level prompt consists of the Ethernet Switch Module "host name" followed by the angle
bracket (>).
console>
The default host name is "Console" unless it has been changed using the hostname command in
the Global Configuration mode.
Privileged EXEC Mode
Privileged access is password protected to prevent unauthorized use because many of the privileged
commands set operating system parameters:. The password is not displayed on the screen and is
case sensitive.
Privileged users enter directly into the Privileged EXEC mode. To enter the Privileged EXEC mode
from the User EXEC mode, perform the following steps:
At the prompt, enter the command enable and press <Enter>. A password prompt is
1
displayed.
Enter the password and press <Enter>. The password is displayed as "*". The Privileged
2
EXEC mode prompt is displayed. The Privileged EXEC mode prompt consists of the device
Ethernet Switch Module "host name" followed by "#".
console#
To return from Privileged Exec mode to User EXEC mode, type the disable command at the
command prompt.
38
Using the CLI
Advertisement
