Advertisement
Command Mode
Interface configuration (Ethernet, port-channel) mode
User Guidelines
•
The timer_value value must be a multiple of 10.
•
You must maintain the following relationship for the various timer values:
–
Leave time must be greater than or equal to three times the join time.
–
Leave-all time must be greater than the leave time.
•
Set the same GARP timer values on all Layer 2-connected devices. If the GARP timers are set
differently on the Layer 2-connected devices, GARP application will not operate successfully.
Example
The following example sets the leave timer for port g16 to 900 milliseconds.
console(config)# interface ethernet g16
console(config-if)# garp timer leave 900
gvrp vlan-creation-forbid
The gvrp vlan-creation-forbid Interface Configuration (Ethernet, port-channel) mode command
enables or disables dynamic VLAN creation. To disable dynamic VLAN creation, use the no form of
this command.
Syntax
gvrp vlan-creation-forbid
no gvrp vlan-creation-forbid
Default Configuration
By default, dynamic VLAN creation is enabled.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
•
This command forbids dynamic VLAN creation from the interface. The creation or
modification of dynamic VLAN registration entries as a result of the GVRP exchanges on an
interface are restricted only to those VLANs for which static VLAN registration exists.
123
GVRP Commands
Advertisement
