Advertisement
sntp unicast client poll
The sntp unicast client poll Global Configuration mode command enables polling for the Simple
Network Time Protocol (SNTP) predefined unicast servers. To disable the polling for SNTP client,
use the no form of this command.
Syntax
sntp unicast client poll
no sntp unicast client poll
Default Configuration
Polling is disabled.
Command Mode
Global Configuration mode
User Guidelines
•
Polling time is determined by the sntp client poll timer Global Configuration mode
command.
Examples
The following example enables polling for the Simple Network Time Protocol (SNTP) predefined
unicast clients.
console(config)# sntp unicast client poll
sntp server
The sntp server Global Configuration mode command configures the Ethernet Switch Module to
use the Simple Network Time Protocol (SNTP) to request and accept Network Time Protocol
(NTP) traffic from a specified server. To remove a server from the list of NTP servers, use the no
form of this command.
Syntax
sntp server {ip-address | hostname}[poll] [key keyid]
no sntp server host
•
ip-address — IP address of the server.
•
hostname — Hostname of the server. (Range: 1 - 158 characters)
•
poll — Enable polling.
•
keyid — Authentication key to use when sending packets to this peer. (Range:1 –
4294967295)
82
Clock
Advertisement
