Advertisement
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
•
An access port would not dynamically join a VLAN because it is always a member in only one
VLAN.
•
Membership in an untagged VLAN would be propagated in a same way as a tagged VLAN. In
this case the PVID must be manually set to be the untagged VLAN VID.
Example
The following example enables GVRP on port g16.
console(config)# interface ethernet g16
console(config-if)# gvrp enable
garp timer
The garp timer Interface Configuration (Ethernet, port-channel) mode command adjusts the
GARP application join, leave, and leaveall GARP timer values. To reset the timer to default values,
use the no form of this command.
Syntax
garp timer {join | leave | leaveall} timer_value
no garp timer
•
join — Indicates the time in milliseconds that PDUs are transmitted.
(Range: 10-2147483640)
•
leave — Indicates the amount of time in milliseconds that the Ethernet Switch Module
waits before leaving its GARP state. The Leave Time is activated by a Leave All Time
message sent/received, and cancelled by the Join message. (Range: 10-2147483640)
•
leaveall — Used to confirm the port within the VLAN. The time in milliseconds between
messages sent. (Range: 10-2147483640)
•
timer_value — Timer values in milliseconds.
Default Configuration
The default timer values are as follows:
•
Join timer — 200 milliseconds
•
Leave timer — 600 milliseconds
•
Leavall timer — 10000 milliseconds
122
GVRP Commands
Advertisement
