Auto Mode - Rigol DS4024E User Manual

Chapter 6 Operations and Measurements

Auto Mode

You can use cursor to perform auto measurement on any of the 29 waveform
parameters. In this mode, one or more cursors will appear. The system will
automatically adjust the cursor positions as well as measure and calculate the
corresponding parameters according to the signal variation.
Note:
To use this mode, at least one auto measurement parameter should already be

measured using the one-key measurement function (refer to "To Make
One-key Measurement"). No cursor will be displayed if no one-key
measurement is executed or the measurement source has no input.
The number of cursors displayed on the screen depends on the measurement

parameter currently selected (different measurement item requires different
number of cursors).
When the waveform is expanded or compressed horizontally, the cursor will

move accordingly.
You can use cursor to perform auto measurement on channel waveform following the
steps below.
1. Turn on the auto measurement function
Press Cursor  Mode, turn the multi-function knob
press the knob. You can also press Cursor or Mode continuously to switch to
"Auto". By default, the instrument measures the measurement item that turned
on lastly (use one-key measurement).
2. Select the measurement item
Press Meas.Para., turn the multi-function knob
measurement item and press the knob. You can also press Meas.Para.
continuously to switch the current measurement parameter. At most 5
measurement parameters that are turned on lastly can be selected.
Note:
If no one-key measurement is performned currently, Meas.Para. is not

available ("None" is displayed).
If new measurement parameter is turned on latterly, the menu items under

Meas.Para. will change accordingly.
DS4000E User's Guide
to select "Auto" and
to select the desired
RIGOL
6-47