Trigger Type; Edge Trigger; Figure 8.3 Edge Trigger Setting Menu - Rigol HDO1000 Series User Manual

Click or tap the trigger information label (as shown in the figure below) or press the
front-panel
on/off switch to enable or disable the noise rejection function.
TIP
This function is available only when the trigger source is set to an analog channel or EXT.
8.7

Trigger Type

This series oscilloscope provides the following trigger types.
8.7.1

Edge Trigger

Edge trigger identifies a trigger on the trigger level of the specified edge on the input
signal.
Trigger Type
Click or tap the Type drop-down button to select "Edge".
After a trigger type is selected, the current trigger setting information (including the
trigger type, source, and level) is displayed in the trigger information label at the top
of the screen, as shown in the figure below. The information will change based on the
trigger settings.
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
key to open the "Trigger" menu. Click or tap the Noise Reject

Figure 8.3 Edge Trigger Setting Menu

Triggering the Oscilloscope
HDO1000 User Guide
69