HP StorageWorks P9000 Manual page 79

Table 12 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKM1x – YKM5x) (continued)
Message ID Message Text
YKM505E ISPF This inter-DKC path is already
defined in another logical
path.
YKM506E ISPF You cannot define inter-DKC
path with this interface version.
YKM507E ISPF The number of connections of
inter-CU paths exceeds the
maximum number of
connections that is allowed
within the same CU.
YKM508E ISPF This inter-CU path is already
defined in another logical
path.
YKM509E ISPF The number of physical paths
that are defined in the same
logical path exceeds the limit.
YKM510E ISPF This Model is not supported for
this Path Type.
YKM51 1E ISPF The value of CU exceeds the
number of CUs that is allowed
in this Model.
YKM512E ISPF The number of logical paths
that are using this port exceeds
the limit.
YKM513E ISPF The number of connections
exceeds the limit that is
allowed within this port.
YKM514E ISPF CCA could not be assigned
because either the path is
already defined in another
logical path, or the list of CCA
could not be retrieved.
YKM515E ISPF You cannot specify the same
serial number to the primary
side and the secondary side of
the same logical path.
YKM516E ISPF Port errport is already defined
as portdir port.
YKM517E ISPF The value of PathID exceeds
the value that is allowed in this
Model.
YKM518E ISPF Port errport exceeds the limit
that is allowed in this
composition.
Explanation and Recommended Actions
This inter-DKC path is already defined in another logical path.
In this interface version, the user cannot define inter-DKC paths.
The number of connections of inter-CU paths exceeded the
maximum that is allowed within the same CU.
This inter-CU path is already defined in another logical path.
The number of physical paths exceeded the maximum that is
allowed within the same logical path.
This model does not support this path type.
The number of CUs exceeds the maximum number for this model.
The number of logical paths that are using this port exceeded
the limit.
The number of connections exceeded the limit that is allowed
within this port.
A command control address could not be assigned because
the path is already defined in another logical path, or because
a list of command control addresses could not be obtained.
The same serial number cannot be specified for both the primary
and secondary sides of the same logical path.
The port errport is already defined as portdir.
errport
The port that you specified
portdir
The port that is already defined
The value of PathID exceeds the maximum for this model.
The number of ports exceeds the maximum number for this
composition.
errport
The port you specified
List of Messages 79