HP StorageWorks P9000 Manual page 77

Table 1 1 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKM0x) (continued)
Message ID Message Text
YKM040E ISPF A Consistency Group ID (C/T
ID,sub C/T ID) is required for
CAJ Copy Group definition.
YKM041E ISPF A sub Consistency Group ID
cannot be specified for BC
Z/CA/TCA Copy Group
definition.
YKM042E ISPF This Consistency Group ID
(C/T ID,sub C/T ID) is
already defined. Choose a
different ID.
YKM043E ISPF A Mirror ID is required for
CAJ Copy Group definition.
YKM044E ISPF This Path Set ID is already
defined.
YKM045E ISPF Physical path (priport secport)
is already defined in this
logical path.
YKM046E ISPF The end CU/CCA value must
not be lower than the start
CU/CCA.
YKM047E ISPF You cannot add a remote
route entry if the specified
DADID matches a local or
Non Gen'ed DADID or if a
scan has already been
performed for the
combination of the specified
DADID and storage system.
YKM048E ISPF You cannot perform a device
scan because in the Set
Defaults panel, a remote DAD
ID or Non Gen'ed DAD ID
was specified as the local
DAD ID.
YKM049E ISPF This storage system can't be
selected because it hasn't
been scanned yet.
YKM050E MSG Invalid Copy Group attribute
SC=36 RC=48 name
(attribute-value)
Explanation and Recommended Actions
For the Cnt Ac-J Z copy group definition, you need to specify a
C/T group ID and a sub C/T group ID.
For the BC Z/Cnt Ac-S Z/TCA copy group definition, you cannot
specify a sub C/T group ID.
This C/T group ID is already defined. Choose a different ID.
For the Cnt Ac-J Z copy group definition, you need to specify a
mirror ID.
This path set ID is already defined.
The physical path is already defined as a logical path.
priport
The primary port you specified
secport
The secondary port you specified
The end CU/command control address value is lower than the
start CU/command control address value.
A remote route entry cannot be added in the following cases:
When the device address domain ID is the same as the local
device address domain ID or Non Gen'ed device address
domain ID.
When the pair of the device address domain ID and storage
system has already been scanned.
Devices cannot be scanned because in the Set Defaults panel,
the remote device address domain ID or Non Gen'ed device
address domain ID has been specified as the local device address
domain ID.
The storage system cannot be selected because it has not yet
been scanned.
The specified copy group attribute value is invalid for this
command.
Correct the value and then re-execute the command.
name
REXX variable name
attribute-value
REXX variable value
List of Messages 77