HP StorageWorks P9000 Manual page 171

Table 44 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKZ40x)
Message ID
YKZ400E MSG SC=48
RC=48
YKZ401E MSG SC=48
RC=48
YKZ402E MSG SC=44
RC=44
YKZ403I MSG SC=0
RC=0
Message Text
param parameter cannot be
specified for copy-type Copy Group.
Some of the storage systems do not
support param.
Unexpected transition occurred while
adding JNLG to EXCTG. (CT ID=jj,
sub CT ID=kk, MIRROR=m,
SN=ssssssssssss, STATE=nnnn)
No pair processed in Copy Groups.
Explanation and Recommended Actions
The parameter indicated by param cannot be
specified for a copy group with a copy type of
copy-type.
Check the copy type and the parameter.
param (string)
The parameter name which
cannot be specified
copy-type (string)
The copy type specified for the
copy group
The storage system which the command is issued
onto, or the storage system which uses the remote
DKC control function, does not support the parameter
indicated by param.
Use a device which supports the parameter indicated
by param. Also, if a scan has not been performed
after the storage system microcode was replaced,
perform another scan.
param (string)
The parameter name which is not
supported
The copy pair entered an unexpected status while
registering the journal group to EXCTG.
Check that the status to be monitored is correctly
specified. If the status is correctly specified, execute
the YKQUERY command to determine the cause of
the problem and rectify the error.
jj (hexadecimal number)
The journal group number specified by the C/T group
ID (00-FF)
kk (hexadecimal number)
The journal group number specified by the sub C/T
group ID (00-FF)
m (decimal number)
Mirror ID (0-3)
ssssssssssss (decimal number)
Storage system serial number
nnnn (string)
The status after the transition
The target copy pair was not found.
Check the volume status, correct errors involved in
the configuration or execution conditions if any, and
then re-execute the command.
If the YKMAKE SELECT(COND) command is issued
on a copy group container with EXCTG ID specified
but without specifying the DEVN parameter, the
EXCTG registration I/O is issued even if this message
is output.
List of Messages 171