HP StorageWorks P9000 Manual page 34

Table 2 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKA0x) (continued)
Message ID
YKB202W TSO
YKB203W TSO
YKB204W TSO
YKC000T TSO
RC=48
34 Messages
Message Text
Unable to resolve primary
volume information.
Pair=CopyType,
DEVN=Devn,
SN=SerialNum, CU=CU#,
CCA= CCA#
Unable to resolve secondary
volume information.
Pair=CopyType,
SN=SerialNum, CU=CU#,
CCA= CCA#
A dynamic configuration
change was detected.
DEVN=device-number
Supplied parameters invalid
Explanation and Recommended Actions
A P-VOL not defined in the disk configuration definition file was
detected among the PPRC copy pairs detected by the YKP2B
command.
Check whether the detected P-VOL is defined in the disk
configuration definition file.
CopyType
The copy type of the detected undefined volume
Devn
The device number of the detected undefined
volume
SerialNum
The storage system serial number of the detected
undefined volume
CU#
The control unit number of the detected
undefined volume
CCA#
The command control address number of the
detected undefined volume
An S-VOL not defined in the disk configuration definition file was
detected among the PPRC copy pairs detected by the YKP2B
command.
Check whether the detected S-VOL is defined in the disk
configuration definition file.
CopyType
The copy type of the detected undefined volume
SerialNum
The storage system serial number of the detected
undefined volume
CU#
The control unit number of the detected
undefined volume
CCA#
The command control address number of the
detected undefined volume
A dynamic change was detected in an I/O configuration definition
while the YKP2B command was executing with CHECK specified
for the HS parameter.
Check the status of the device targeted by the YKP2B command,
correct any errors in the configuration or execution conditions, and
then re-execute the command.
device-number
Device number being processed when a dynamic
change was detected in an I/O configuration
definition
Invalid parameters are specified.
For details, see the reason code in the YKC099I message displayed
after this message. For reason codes, see IKJPARS in the TSO/E
Programming Services.