HP StorageWorks P9000 Manual page 215

Table 56 Details of Error Codes 7Fxx – 8Cxx
Error Error Details
Code
The command cannot be executed
7F86
because no program product for
copying is installed.
This command is not supported.
7FD4
A Cnt Ac-S Z or TCA copy pair
8C12
status cannot be changed. Possible
reasons include one or more of the
following:
The specified S-VOL is online.
The specified volume is either a
Cnt Ac-S Z or TCA pair volume,
or the S-VOL of a BC Z copy
pair.
All paths to the RCU are blocked.
The status of the copy pair is not
possible for the requested
transition (it is possible that it is
already in requested copy pair
status).
The logical volume of the
specified volume is blocked.
The path between the primary site
and the secondary site is in the
BUSY status.
The emulation type of the P-VOL
and the S-VOL do not match.
Alternatively, the number of
cylinders in the S-VOL is less than
the P-VOL.
Either the status of the P-VOL is
being changed, or there is a
copy pair in the group with the
status being changed.
The command could not be
executed because the specified
Cnt Ac-S Z or TCA volume is in
the SIMPLEX status.
The S-VOL is not in the
SWAPPING status.
Either the status of the P-VOL is
being changed, or there is a
copy pair in the group with the
status being changed.
A copy pair cannot be made
because the same C/T group ID
is set in both the MCU and RCU.
The specified C/T group ID is not
registered.
Alternatively, a path cannot be
defined and deleted because
either the copy pair status or the
parameter is invalid. (The
possible reasons are documented
by error codes C120 to C12F.)
Type of Error
BC Z Cnt Ac-S Z
Not output
Not output
Not Output
output
TCA Cnt Ac-J Z CMD
Not output
Details of Error Codes
PATH Others
Output
Output
Output
215