HP StorageWorks P9000 Manual page 179

Table 45 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKZ41x)
Message ID
YKZ410E MSG SC=36
#1
RC=36
YKZ41 1E MSG SC=36
RC=48
YKZ412E MSG SC=36
RC=48
Message Text
Copygroup SUPFnc does not support
CAJ Errorlevel.
CAJ parameter is only valid for BC Z
Copy Groups with C/T ID.
This device SUPFnc does not support
CAJ ATTIME.
Explanation and Recommended Actions
You cannot use the Errorlevel attribute for this
storage system.
#2
In this case, use a device
Errorlevel attribute for Cnt Ac-J Z. Also, if a scan
was not performed after the storage system
microcode was replaced, perform another scan.
SUPFnc (hexadecimal number)
Value for the version of the
storage system support function
used in the copy group
(minimum)
#1
If this message is output while the YKLOAD
command is being executed, the RC is 44.
#2
The Errorlevel for Cnt Ac-J Z can be used in a
storage system where the version of the storage
system support function is X'12' or higher.
The YKSUSPND command with the ATOPT(Cnt
Ac-J Z) parameter specified was executed on a
copy group other than an BC Z copy group with
the C/T group ID specified. The ATOPT(Cnt Ac-J
Z) parameter is only valid on BC Z copy groups
with the C/T group ID specified.
Re-execute the YKSUSPND command without
specifying the ATOPT parameter, or with the
ATOPT(NORMAL) parameter specified.
The CAJ ATTIME suspend function is not available
for this storage system.
#
Use a device for which the CAJ ATTIME suspend
function is supported. Also, if scanning was not
performed after the storage system microcode was
replaced, perform another scan.
SUPFnc (hexadecimal number)
Value for the version of the
storage system support function
used in the copy group
(minimum)
#
The CAJ ATTIME suspend function can be used
in a storage system where the version of the storage
system support function are X'14' or higher.
that supports the
List of Messages 179