HP StorageWorks P9000 Manual page 165

Table 42 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKZ29x) (continued)
Message ID
Y0KZ297E MSG SC=44
RC=44
YKZ298W MSG SC=4
RC=4
Message Text
An error occurred while adding
JNLG to EXCTG. (JNLG=jj,
MIRROR=m, EXCTG=e,
SN=ssssssssssss, CDEV=cccc,
CODE=nnnn)
Timeout limit has expired while
waiting for EXCTG registration
process.
Explanation and Recommended Actions
An error occurred while registering the journal group
to EXCTG.
Register the error code and determine the cause of
the problem. After removing the cause of the
problem, execute the YKMAKE command again with
a SELECT(COND) specification to register the journal
group to EXCTG.
This message is output until the corresponding EXCTG
registration process is executed using the YKMAKE
command again.
JNLG (string)
The journal type not being
registered (the journal type of the
definition, rather than of the
storage system)
R-JNL: Journal of the secondary
site
M-JNL: Journal of the primary site
jj (hexadecimal number)
The journal group number
specified by the C/T group ID or
the sub C/T group ID (00-FF)
m (decimal number)
Mirror ID (0-3)
e (decimal number)
EXCTG ID (0-3)
ssssssssssss (decimal number)
Storage system serial number
cccc (hexadecimal number)
Arbitration command device
number (0000-3FFF)
FFFF is displayed for the
supervisor DKC.
nnnn (hexadecimal number)
Error code
For details about the error codes,
see "Storage System Sense Byte
Information" (page
Processing is terminating because the timeout limit
has expired while waiting for the EXCTG registration
with the YKEWAIT command.
Correct the timeout value or check that the status to
be monitored is correctly specified. Also, check if the
journal group is registered to EXCTG.
The REXX variable is invalid (remains as it was prior
to the YKEWAIT command) if this message is output.
189).
List of Messages 165