HP StorageWorks P9000 Manual page 143

Table 37 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKZ21x – YKZ24x) (continued)
Message ID
YKZ239E MSG SC=48
RC=48
YKZ240E MSG SC=48
YKZ241W MSG SC=4
RC=0
YKZ242E MSG SC=48
RC=48
YKZ243E MSG SC=48
RC=48
YKZ244E MSG SC=36
RC=36
YKZ245E MSG SC=48
RC=48
YKZ246E MSG SC=48
RC=48
Message Text
The specified Copy Group has no
CA Synchronous Group.
The specified pair was not found in
the Copy Group.
(DEVN=P-VOL-device-number,
S-VOL-device-number)
No I/O issued volume is in Copy
Groups.
The pair needs to be swapping, but
is not.
Supplied parameters invalid
Storage system serial-number is not
found in Routelist.
CopyGroup attribute combination is
invalid.
This operation (operation) does not
support remote command.
Explanation and Recommended Actions
The specified copy group is not a Cnt Ac-S Z with a
C/T group ID specified.
Confirm that the copy group is a Cnt Ac-S Z copy
group with a consistency group ID specified and is
a Cnt Ac-S Z copy group for which the Open/MF
Consistency attribute is not set. After that, re-execute
the command.
A copy pair corresponding to the device number
specified in the DEVN parameter was not found in
the copy group.
There is no volume eligible for I/O issuance.
Check the volume status, correct errors involved in
the configuration or execution conditions if any, and
then re-execute the command.
You cannot execute the YKRESYNC command to
change the copy direction before suspension,
because the copy pair status is not SWAPPING or the
status of the copy pairs has not been acquired.
Check the status of the volumes in the copy group,
correct the YKRESYNC command parameter
specification, and then re-execute the command.
When executing the YKRESYNC command with the
FORWARD/REVERSE parameter, execute the
YKQUERY command or YKEWAIT command to
acquire the status of the copy pairs immediately
before the YKRESYNC command.
ATTIME or CANCEL is specified together with SVOL.
Correct the YKSUSPND command parameter values,
and then re-execute the command.
The specified storage system does not exist in the
route list.
serial-number
Storage system serial number
The combination of the specified command or the
operand, and copy group attribute is invalid.
Check the configuration file to make sure that the
configuration allows command execution, and
execute the command again.
This operation is not supported when a remote
function is in use.
operation
Operation name
List of Messages 143