HP StorageWorks P9000 Manual page 72

Table 10 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKL2x) (continued)
Message ID
YKL281E MSG
SC=36 RC=36
(file:rec#)
YKL284E MSG
SC=36 RC=36
(file:rec#)
YKL290E MSG
SC=44 RC=44
(result)
YKL291E MSG
SC=36 RC=36
72 Messages
Message Text
No command device of the
storage system in remote
command route is defined.
PVOL & SVOL of BC Z pair is
in the different storage
system.
YKVGET program failure for:
vn
function-name is not licensed
for use on this system.
Explanation and Recommended Actions
No command device is found that corresponds to the storage
system defined in the route for remote command issuance.
Correct the route definition in the route list definition file identified
by file.
file
Name of the XML file where the error was
detected
rec#
Number of the line in the file identified by file
where the error was detected
In a file for a copy group of the BC Z copy type, a copy pair has
been discovered for which the storage system serial numbers of
the P-VOL and S-VOL do not match.
Correct the line with the line number identified by rec# in the file
identified by file.
file
Name of the XML file where the error was
detected
rec#
Number of the line in the file identified by file
where the error was detected
An attempt to acquire the variable vn failed with the result value
identified by result. This error can be caused by an invalid value
being specified for the STEM parameter.
The license key for the function identified by function-name has
not been installed, has expired, or is not correctly recognized.
Check whether the license key is available for this version.
If function-name is This product:
Business Continuity Manager commands cannot be used because
the Business Continuity Manager license key has not been installed.
If function-name is Cnt Ac-S Z Sync Extended CTG:
No C/T group ID can be specified for the Hitachi TrueCopy™ for
Mainframe (Cnt Ac-S Z) copy group because the license key
required for the function for preserving consistency has not been
installed.
If function-name is Cnt Ac J 4x4 Extended CTG:
The function for preserving consistency on an EXCTG basis cannot
be used because the license key required for a 4x4 configuration
has not been installed.