HP StorageWorks P9000 Manual page 44

Table 7 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKG0x) (continued)
Message ID
YKG077W MSG
SC=4 RC=4
(file:rec#)
YKG079E MSG
SC=44 RC=44
(result)
YKG085E MSG
SC=40 RC=40
(file:rec#)
YKG088E MSG
SC=40 RC=40
(file)
YKG089E MSG
SC=40 RC=40
(file)
44 Messages
Message Text
APIInfo Level=level invalid.
Supported level isv.r.m.
YKVSET program failure for:
name = value
Unable to read configuration
file.
File Open error: dsstate.
File Close error: dsstate.
Explanation and Recommended Actions
The system does not recognize the Level attribute level of the APIInfo
element that exists on the line with the line number identified by
rec# in the file identified by file.
Check the indicated line, and then identify the cause of the problem
by referring to information contained in the XML document type
definitions, in the HP StorageWorks P9000 for Business Continuity
Manager Software Reference Guide.
file
Name of the XML file where the error was
detected
rec#
Number of the line in the file identified by file
where the error was detected
v.r.m
API level
For details about this value, see the information
about the XML document type definitions in the
HP StorageWorks P9000 for Business Continuity
Manager Software Reference Guide.
This error can be caused by an invalid value being specified for
the STEM parameter.
The configuration file could not be read, because the record length
is too long.
file
Name of the XML file where the error occurred
rec#
Number of the line in the file file where the error
was detected
An attempt to open the XML file identified by file failed.
dsstate
Status of the input XML file
file
Name of the XML file where the error was
detected
An attempt to close the XML file identified by file failed.
dsstate
Status of the input XML file
file
Name of the XML file where the error was
detected