HP StorageWorks P9000 Manual page 243

Table 62 Details of Error Codes C3xx (continued)
Error Error Details
Code
The S-VOL is not in the suspend
C3DB
status.
A copy pair cannot be made
C3FE
because TCA and Cnt Ac-S Z
cannot be specified simultaneously.
Commands that use Cnt Ac-S Z
C825
copy pairs, Cnt Ac-J Z copy pairs,
or the Remote DKC Control
Function cannot be executed
because the number of executable
paths is less than the minimum
value.
Table 63 Details of Error Codes CBxx
Error Error Details
Code
A copy pair cannot be made
CB10
because there was an attempt to
make a copy pair for both
directions with the same C/T group
ID.
A copy pair cannot be added to a
CB18
C/T group where the P-VOL and
the S-VOL are being swapped.
A dummy volume cannot be
CB1D
created on the S-VOL.
The current RCU version does not
CB1F
support Fibre Cnt Ac-S Z or TCA.
Fibre Cnt Ac-S Z or TCA has not
CB60
been installed on the RCU.
Copy pairs with Fibre and ESCON
CB61
paths cannot exist within the same
C/T group.
Copy pairs with Fibre and ESCON
CB62
paths cannot exist within the same
storage system.
The storage system type of the
CB64
MCU is not supported (not
3990-6/6E, or is 2105).
The upper limit of 4,096 (or more)
CB69
copy pairs cannot be made within
the same C/T group by RCU.
A copy pair cannot be made
CB78
because the specified S-VOL is
defined as a command device.
Type of Error
BC Z Cnt Ac-S Z
Not Output
output
Not output
Not Output
output
Type of Error
BC Z Cnt Ac-S Z
Not output
Not output
Not Output
output
Not Output
output
Not Output
output
Not output
Not Output
output
Not Output
output
Not output
Not Output
output
TCA Cnt Ac-J Z CMD
Not output
Output Not output
Not Output
TCA Cnt Ac-J Z CMD
Output Not output
Output Not output
Not output
Not output
Not output
Output Not output
Not output
Not output
Output Not output
Not output
PATH Others
Output
PATH Others
Details of Error Codes 243