HP StorageWorks P9000 Manual page 110

Table 31 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKY1x)
Message ID
YKY100I CON
YKY101I CON
YKY102I CON
YKY103I CON
YKY104I CON
YKY1 1 1I CON
YKY1 14I CON
YKY130I CON
1 10 Messages
Message Text
MODIFY COMMAND
ACCEPTED
STOP COMMAND ACCEPTED
INVALID error-type: text
COMMAND SYNTAX ERROR
OPERAND IS INCORRECT
parameter-name WAS
CHANGED
parameter-name=
parameter-value
SESSION NO.=session-number
Explanation and Recommended Actions
The MODIFY command was accepted.
The STOP command was accepted.
After an entry of the MODIFY command, an error was
detected in the command or operand shown as text.
Check, and, if necessary, revise the command.
error-type
COMMAND: Indicates that an error was detected in
the command.
OPERAND: Indicates that an error was detected in
the operand.
The entered command has a syntax error.
Check, and, if necessary, revise the command.
The specified operand is invalid.
Correct the error and then re-enter the operand.
The value of the initialization parameter has been
changed. The parameter name is given in
parameter-name.
This message displays the current value of the
initialization parameter.
parameter-name
Initialization parameter name
parameter-value
Initialization parameter value
This message displays the TCP/IP session number.
This message is followed by the TCP/IP session
information.
session-number
Session identification number