Lucent Technologies PARTNER Advanced Communications System Programming And Use Instructions page 397

VMS Hunt Schedule (#507)
Programming
For Release 2.0 or Earlier:
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
s
as
To change the VMS Hunt Schedule setting for the voice messaging system's
Automated Attendant Service:
1. Press
10 or 11.
2. Press
3. Select another procedure or exit programming mode.
For Release 3.0 or Later:
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
s
as
To change the VMS Hunt Schedule setting for the voice messaging system's
Automated Attendant Service:
1. Press
10 or 11.
2. Enter the line number.
The current setting displays.
3. To set VMS Hunt Schedule, press
displays. (See "Valid Entries" above.)
4. To set VMS Hunt Schedule for another line, press
the line number shows on the display. Then repeat Step 3.
5. Select another procedure or exit programming mode.
e
and on system phones.)
f 0 0 s s # 5 0 7
D
until the appropriate value displays.
e
and on system phones.)
f 0 0 s s # 5 0 7
D
until the appropriate value
n
at extension
at extension
p
or until
5-287