Lucent Technologies PARTNER Advanced Communications System Programming And Use Instructions page 395

VMS Hunt Delay (#506)
Valid Entries
For Release 3.0 or Later:
Mode
1 = Day
2 = Night
Number of Rings
0 - 6
2
Programming
For Release 2.0 or Earlier:
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
s
as
To change the VMS Hunt Delay setting for the voice messaging system's
Automated Attendant service:
1. Press
10 or 11.
2. Press
3. Select another procedure or exit programming mode.
For Release 3.0 or Later:
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
s
as
To change the VMS Hunt Delay setting for the voice messaging system's
Automated Attendant service:
1. Press
10 or 11.
2. Select Day or Night mode by entering
3. Enter the line number.
The current setting displays.
4. To set VMS Hunt Delay, press
(See ''Valid Entries'' above.)
5. To set VMS Hunt Delay for another line, press
line number shows on the display. Then repeat Step 4.
6. Select another procedure or exit programming mode.
e
and on system phones.)
f 0 0 s s # 5 0 6
D
until the appropriate value displays.
e
and on system phones.)
f 0 0 s s # 5 0 6
1 2
or respectively.
D
until the appropriate value displays.
n
at extension
at extension
p
or until the
5-285