Lucent Technologies PARTNER Advanced Communications System Programming And Use Instructions page 201

Contact Closure (F41 and F42)
Programming
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
s
as
To program a Contact Closure button:
1. Press
10 or 11.
2. Enter the number of the extension to be programmed with this feature.
3. Press a programmable button, preferably one with lights.
4. Press
Closure 2).
5. Program another button for this extension or exit programming mode.
Using
System Phone
To activate a Contact Closure:
1. Press the programmed button or press
f 4 2
1) or
The green light is on steady.
2. If the Contact Closure Operation Type for that Contact Closure is set to
Toggle, repeat Step 1 to deactivate the Contact Closure.
The green light goes off.
Standard Phone
To activate a Contact Closure:
1. Pick up the handset to get an intercom dial tone.
2. Press
(for Contact Closure 2).
3. If the Contact Closure Operation Type for that Contact Closure is set to
Toggle, repeat Steps 1 and 2 to deactivate the Contact Closure.
e
and on system phones.)
f 0 0 s s c
f 4 1
(for Contact Closure 1) or
(for Contact Closure 2).
# 4 1
(for Contact Closure 1) or
at extension
f 4 2
(for Contact
f 4 1
(for Contact Closure
# 4 2
5-91