Lucent Technologies PARTNER Advanced Communications System Programming And Use Instructions page 270

Feature Reference
Example
A supermarket installs a hotline phone at its meat counter. When a customer uses
the hotline phone, the butcher's phone rings. Alternatively, if the loudspeaker
paging system is programmed as the alert extension, a sales clerk could request
a "price check" over the loudspeaker simply by lifting the handset of the hotline
phone.
Programming
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
s
as
To identify a hotline extension and its alert extension:
1. Press
extension 10 or 11 .
2. At the Extension: prompt, enter the hotline extension number—see
"Valid Entries" on the previous page. For example, to program extension 33
as the hotline, press
3. At the Data - - - - - - - - - - - - prompt, enter the alert extension number—
see "Valid Entries" on the previous page. For example, to program
extension 32 as the alert extension, press
following appears:
Internal Hotline Ext 33
Data 32
4. At this point:
5. Select another procedure or exit programming mode.
Using
To use the hotline phone:
1. Lift the handset of the hotline phone.
The designated alert extension rings.
2. When the call is answered, speak into the handset.
5-160
e
and on system phones.)
f 0 0 s s # 6 0 3
3 3
.
To change the hotline and alert extension numbers you just entered,
repeat Steps 2 and 3.
To delete the existing hotline and alert extension numbers, press
r
.
To identify another hotline and alert extension pair, press
p
until the new hotline extension number shows on the
display. Then repeat Step 3.
at
3 2
. A display similar to the
n
or