Lucent Technologies PARTNER Advanced Communications System Programming And Use Instructions page 268

Feature Reference
Programming
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
s
as
To change the hold disconnect time:
1. Press
10 or 11.
2. At the Line: prompt, enter the two-digit number of the line for which you
are adjusting the hold disconnect time.For example, to adjust line 1, press
0 1
The current hold disconnect time for the line number you specified is
displayed. For example, if line 1 is set to the default setting, 09 – 450 msec
shows in the display.
3. To change the hold disconnect time, press
value displays.
4. To program the next line, press
5. Repeat Step 4 for each line in the system.
6. Select another procedure or exit programming mode.
5-158
e
and on system phones.)
f 0 0 s s # 2 0 3
.
D
until the appropriate
n
, then repeat Step 3.
at extension