Lucent Technologies PARTNER Advanced Communications System Programming And Use Instructions page 158

Feature Reference
The user at an extension who has activated Call Coverage can intercept an
outside call routed for coverage by pressing the outside line button.
You can program Call Coverage on a button on a system phone. Use a
button with lights if you want a visual indication when your calls are being
covered. When the green light is on, your calls are being covered; when the
green light is off, Call Coverage is not active.
If the Call Coverage feature code and optional originating and covering
extensions are programmed on a button with lights, you can use the button
to turn Call Coverage on and off with one touch. (The lights show when Call
Coverage is on, even if calls are covered by a different extension than the
one stored on the button, and you can still use the button to turn Call
Coverage off.)
Programming
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
s
as
To program a Call Coverage button:
1. Press
2. Enter the number of the extension to be programmed with this feature.
3. Press a programmable button, preferably a button with lights.
4. At this point, you can do one of the following:
5. Program another button for this extension or exit programming mode.
Using
System Phone
To send calls for coverage manually:
1. Press
2. Dial your extension number.
3. Dial the extension number of the covering extension.
To remove Call Coverage manually:
1. Press
2. Dial your extension number twice.
5-48
e
and on system phones.)
f0 0 s s c
f2 0
Press .
f20
Press and the number of the originating extension.
f20
Press the number of the originating extension, and the
number of the covering extension.
f20
.
f2 0
.
.