Call Coverage Rings (#320) -Release 3.0 Or Later - Lucent Technologies PARTNER Advanced Communications System Programming And Use Instructions

Call Coverage Rings (#320) —Release 3.0 or Later
Call Coverage Rings (#320)
—Release 3.0 or Later
Description
This System Programming procedure defines the number of times intercom,
transferred, and outside calls on lines assigned ownership ring at an extension
before they are sent to the covering extension. Unlike Call Coverage Rings
(#116) in Release 2.0, Call Coverage Rings in Release 3.0 is programmable on an
individual extension basis.
Related Features
Call Coverage redirects an extension's covered calls to the covering
extension.
You must use Line Coverage Extension (#208) to designate an extension
as the owner of a specific outside line, so the extension can activate Call
Coverage for that line.
If an extension has Call Coverage and VMS Cover active, covered calls
ring at the covering extension for the specified number of Call Coverage
Rings. Then:
— If the covering extension does not answer, the call is routed to the
— If the covering extension has Do Not Disturb active, the call is
Valid Entries
1–9
2
Programming
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
s
as
To change the number of times a call rings at an extension before it is sent to the
covering extension:
1. Press
2. Enter the extension number. The current ring setting displays.
3. To set Call Coverage Rings, press
displays. (See "Valid Entries.")
4. To set Call Coverage Rings for another extension, press
p
Step 3.
5. Select another procedure or exit programming mode.
voice mailbox of the extension that activated Call Coverage after the
specified number of VMS Cover Rings (#117) or (#321).
routed immediately to the voice mailbox of the extension that
activated Call Coverage.
e
and on system phones.)
0 0 s s# 3 2 0
until the extension number shows on the display. Then repeat
.
D
until the appropriate value
n
or
5-51