Lucent Technologies PARTNER Advanced Communications System Programming And Use Instructions page 252

Feature Reference
Programming
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
s
as
To create a Forced Account Code List:
1. Press
10 or 11.
2. Select a list entry (01–99). For example, to select the third entry, press
3
. A display similar to the following appears:
Forced Act Code List 03
Data - - - - - - - - - - - -
3. Enter up to six digits for the list entry.
4. If the account code is five digits or less, you must press
account code in memory.
5. At this point:
6. Select another procedure or exit programming mode.
5-142
e
and on system phones.)
f 0 0 s s # 4 0 9
To enter other account codes, press
entry and repeat Steps 3 and 4.
To change the account code you just entered, press
repeat Steps 3 and 4.
To delete the account code you just entered, press
at extension
e
to save the
n
to select a different list
r
r
.
0
and