Lucent Technologies PARTNER Advanced Communications System Programming And Use Instructions page 217

Direct Extension Dial Record/Playback (I892)—Release
2.0 or Later
Using
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
s
as
To record a Direct Extension Dial message:
1. Turn off Direct Extension Dial and Automatic System Answer at
extension 10 and wait for any calls in the process of being answered by
these features to be completed.
2. Lift the handset of the system display phone at extension 10.
3. Press the
8 9 2
4. Dial
display for the duration of this procedure. The top line of the display reads:
DXD: 1=Record
If a message was previously recorded, a display similar to the following
appears:
DXD: 1=Record 2=Play
5. Press
Record at the tone
After three seconds, you hear a tone and you can begin recording your
message. While you are recording, the following display appears:
Press # to stop
6. Press
If the allotted time (40 seconds) for the message is completed before you
press
recording.
When you finish recording, a display similar to the following appears:
DXD: 1=Record 2=Play
7. At this point:
To play back a Direct Extension Dial message:
1. Turn off Direct Extension Dial and Automatic System Answer at
extension 10 and wait for any calls in the process of being answered by
these features to be completed.
2. Lift the handset of the system display phone at extension 10 or 11.
e
and on system phones.)
i
button.
. The current time of day remains on the second line of the
1
. A display similar to the following appears for three seconds:
#
when you are done recording.
#
, you hear a tone to let you know that the system has stopped
To re-record the message, follow the instructions from Step 5 in this
procedure.
To play back the message, follow the instructions from Step 5 in the
playback procedure that follows.
To exit the procedure, hang up the handset.
5-107