Assembling Mlx Telephones - AT&T MERLIN LEGEND Release 3.0 Installation Manual

Assembling MLX Telephones

Assembling MLX Telephones
You will need to assemble an MLX telephone before connecting it to the
control unit. For all other telephones, skip to "Connecting Telephones to the
Control Unit."
Considerations
Review the following items before you begin the procedure:
MLX telephones are packed with the deskstand in the low position.
You can use the deskstand as is, raise it to a higher angle, or remove
it. To adjust or remove the stand, see Step 1 of the following
instructions. (The diagram on the bottom of the user card tray also
shows how to adjust the stand.)
You cannot wall-mount MLX-20L and MLX-28D telephones.
If you wish to wall-mount an MLX-10, MLX-10D, or MLX-10DP
telephone, you must remove the deskstand first. (Wall-mounting an
MLX-10D or 10DP telephone can make the display hard to read.)
A 630B Phonemount (not included) is also required to mount an MLX-
10, MLX-10D, or MLX-10DP telephone on the wall.
To connect an adjunct (such as an alert, modem, or fax machine) to an
MLX telephone, the telephone must have an MFM installed in it. If you
have not already done so, refer to "installing Multi-Function Modules, "
earlier in this chapter.
3-48 Installing Telephones and Adjuncts