AT&T MERLIN LEGEND Release 3.0 Installation Manual page 221

Testing the System
c Hang up the handset.
Recall
d Press the
without a programmed Recall button, press the
and the password before picking up the handset.)
775
e Pick up the handset and make an outside call.
f Verify that you have good two-way communication and hang up.
At the operator console, press the Night Service button again. If you used
9
a password in Step 1, enter the password again. Verify that the Night
Service LED turns off.
Testing the Dictation System
If dictation equipment has not been installed, skip this test. Place a call to
verify that you can access the dictation system.
To access the dictation system, follow the steps below:
1 At the test telephone, pickup the handset.
2 Dial the access code and the number associated with the dictation
equipment.
3 Verify that the ready tone is transmitted.
4 Test the transmission in both directions; make a recording and play it
back.
5 Hang up.
Testing the Paging System
To test the paging system, follow the steps below:
1 Pick up the handset at the test telephone and dial the number for a
particular zone
If ZoneMate 9 paging equipment is in use with PagePac 20, get an
acknowledge tone first and then dial the zone code to make an
announcement. You may hear a confirmation tone.
7–16 Initializing and Testing the System
button and dial the password. (On an MLX telephone
Feature
button and dial