AT&T MERLIN LEGEND Release 3.0 Installation Manual page 219

Testing the System
6 At any telephone, pickup the handset and dial the group extension
number.
7 Test the calling group delay announcement (if provided) for each group.
a Make the group busy or have all members log out of the group (by dialing
at each group extension).
#*44
b Repeat Step 2.
c After listening to the delay announcement, hang up.
d Repeat these steps for each group.
8 At the ringing telephone, have someone pickup the handset and verify
that you have good two-way communication.
System Speed Dial Test
To test System Speed Dial numbers, follow the steps below:
1 Find out which numbers have been programmed for System Speed Dial.
See the system manager or use Form 10b as a reference for System Speed
Dial numbers.
2 From the test telephone, pickup the handset and dial a System Speed
Dial code.
Verify that you have good two-way communication and that the correct party
was reached.
Coverage Test
To verify that coverage is in effect, follow the steps below:
Have someone call the covered telephone.
1
Count the number of rings at the covered telephone before the covering
2
telephone starts ringing.
This should be the same as the programmed number of rings.
3 Pick up the handset at the covering telephone and verify that you have
good two-way communication.
4 Hang up the handset at the covering telephone.
5 Check both Individual and Group Coverage.
7–14 Initializing and Testing the System