Rip Route Redistribution Configuration - HP GbE2c - Blc Layer 2/3 Fiber SFP Option Interface Manual

Table 156 RIP Interface Configuration controls
Control
Multicast Updates?
Split Horizon?
RIP Metric (1-15)
Authentication Type
Authentication Key

RIP Route Redistribution Configuration

NOTE: This form is available only on the GbE2c Layer 2/3 Ethernet Blade Switch.
To display the following form, select Layer 3 > Routing Information Protocol > Static Route Redistribution, Fixed
Route Redistribution, OSPF Route Redistribution, or OSPF External Route Redistribution.
The following table describes the RIP Route Redistribution Configuration controls:
Table 157 RIP Route Redistribution Configuration controls
Control
Metric (1-15, 0 = none)
Route Maps Available
Out Route Map List
Descriptions
Enables or disables multicast updates of the routing table (using address 224.0.0.9). The
default value is disabled.
Enables or disables split horizon. The default value is enabled.
Configures the route metric, which indicates the relative distance to the destination. The
default value is 1.
Configures the authentication type. The default is
Configures the authentication key password.
Descriptions
Exports the routes of this protocol in which the metric and metric type are specified. To
remove a previous configuration and stop exporting the routes of the protocol, enter 0
(none).
Lists the route maps that can be added to the list of OSPF static route.
Lists the route maps that are members of the RIP route.
Select a route map number in the Route Maps Available list and click Add to add the
route map to the list of RIP Redistribution routes.
Select a route map number in the Out Route Map list and click Remove to remove the
route map from the list of RIP Redistribution routes.
.
none
Configuring the switch 189