Route Map Access Path Configuration
NOTE:
This form is available only on the GbE2c Layer 2/3 Ethernet Blade Switch.
To display the following form, go to the Route Map Configuration form. Click Add Access Filter.
The following table describes the Access Path Configuration controls:
Table 138
Access Path Configuration controls
Control
Access Path Identifier (1-8)
AS number (0-65535, 0=none)
Action
Enabled?
Description
Assigns the access path number.
Sets the Autonomous System filter's path number.
Permits or denies Autonomous System filter action.
Enables or disables the Autonomous System filter.
Configuring the switch 169