HP GbE2c - Blc Layer 2/3 Fiber SFP Option Interface Manual page 122

The following table describes Switch TACACS+ Configuration controls:
Table 95 Switch TACACS+ Configuration controls
Control
Primary Tacacs+ IP Address
Secondary Tacacs+ IP Address
Tacacs+ port (1-65000)
Tacacs+ timeout (4-15)
Tacacs+ retries (1-3)
Enable/Disable Tacacs+ Server
Enable/Disable Tacacs+ Backdoor for telnet
Enable/Disable Tacacs+ new privilege level
mapping
Tacacs+ Secret
Secondary Tacacs+ Server Secret
Tacacs+ User Mappings Configuration
IMPORTANT: If TACACS+ is enabled, you must login using TACACS+ authentication when connecting via the
console or Telnet/SSH/HTTP/HTTPS. Backdoor for console is always enabled, so you can connect using
notacacs and the administrator password even if the backdoor (telnet) or secure backdoor (secbd) are
disabled.
If Telnet backdoor is enabled (telnet ena), type in notacacs as a backdoor to bypass TACACS+
checking, and use the administrator password to log into the switch. The switch allows this even if TACACS+
servers are available.
If secure backdoor is enabled (secbd ena), type in notacacs as a backdoor to bypass TACACS+
checking, and use the administrator password to log into the switch. The switch allows this only if TACACS+
servers are not available.
Description
Configures the primary TACACS+ server address.
Configures the secondary TACACS+ server address.
Configures the number of the TCP port to be configured, between 1 and
65000. The default is 49.
Configures the amount of time, in seconds, before a TACACS+ server
authentication attempt is considered to have failed. The default timeout is
5 seconds.
Configures the number of failed authentication requests before switching
to a different TACACS+ server. The default retry count is 3 requests.
Enables or disables the Tacacs+ server.
Enables or disables the Tacacs+ backdoor for telnet. Telnet also applies
to SSH/SCP connections.
Enables or disables TACACS+ privilege-level mapping.
The default value is disabled.
Configures the shared secret (up to 32 characters) between the switch
and the TACACS+ server.
Configures the secondary shared secret (up to 32 characters) between the
switch and the TACACS+ server.
Maps a TACACS+ privilege level to a GbE2c user level, as follows:
Remote Privilege
Enter a TACACS+ privilege level (0-15)
Local Privilege
Select the corresponding GbE2c user level.
Configuring the switch 122