ACL Re-Mark Configuration
To display the following form, go to the ACL Configuration Table form, and select an ACL number, or open the
Access Control Lists folder and click Add ACL.
The following table describes the ACL Re-mark configuration controls:
Table 172
ACL Re-mark Configuration controls
Control
Set in profile update method
Set in profile user update
priority (0-7)
Set in profile update DSCP
enable
Set in profile update DSCP
(0-63)
Set out of profile update DSCP
enable
Set out of profile update DSCP
(0-63)
Description
Defines the method used to update 802.1p priority updates, as follows:
User defined – Sets the 802.1p priority for In-Profile packets based on the configured
value.
Use TOS precedence – Maps the TOS (Type of Service) priority to 802.1p priority for
In-Profile packets.
Disabled – Disables 802.1p priority mapping for In-Profile packets.
Defines 802.1p value. The value is the priority bits information in the packet structure.
Enables or disables DSCP updates for In-Profile packets.
Sets the DiffServ Code Point (DSCP) of In-Profile packets to the selected value.
Enables or disables DSCP updates for Out-of-Profile packets.
Sets the DiffServ Code Point (DSCP) of Out-of-Profile packets to the selected value.
Configuring the switch 205