The following table describes OSPF Hosts Configuration controls:
Table 152
OSPF Hosts Configuration controls
Control
Search Operation
OSPF Host Configuration
NOTE:
This form is available only on the GbE2c Layer 2/3 Ethernet Blade Switch.
To display the following form, go to the OSPF Hosts Configuration form. Select a host number, or open the OSPF
Hosts folder and click Add OSPF Host.
The following table describes the OSPF Host Configuration controls:
Table 153
OSPF Host Configuration controls
Control
Host Identifier (1-128)
IP Address
Enabled?
Area Number (0-2)
Output Cost (1-65535)
Description
To focus the search for an OSPF host, enter search parameters:
Host ID
IP address and subnet mask
Area number
State
Fields that have a value of "any" are ignored during the search.
Choose a search operation:
or: Search for OSPF hosts specified in the Search range that meet any of the criteria
entered.
and: Search for OSPF hosts specified in the Search range that meet all of the criteria
entered.
Click Search to display OSPF hosts that fit the range and meet the criteria entered.
Descriptions
Assigns a numeric identifier to the OSPF host.
Defines the base IP address for the host entry.
Enables or disables the OSPF virtual link.
Defines the area index used by the OSPF host.
Defines the cost value of the host.
Configuring the switch 185
Need help?
Do you have a question about the GbE2c - Blc Layer 2/3 Fiber SFP Option and is the answer not in the manual?