Rip Interface Configuration - HP GbE2c - Blc Layer 2/3 Fiber SFP Option Interface Manual

RIP Interface Configuration

NOTE: This form is available only on the GbE2c Layer 2/3 Ethernet Blade Switch.
To display the following form, go to the RIP Interfaces Configuration form. Select a RIP interface number, or open
the RIP Interfaces folder and click Add RIP Interface.
The following table describes the RIP Interface Configuration controls:
Table 156 RIP Interface Configuration controls
Control
IP Interface number (1-255)
Enable RIP?
RIP Version
Default Route Action
Supply Route Updates?
Listen to Route Updates?
Poisoned Reverse?
Triggered Updates?
Descriptions
Assigns a numeric identifier to the RIP interface.
Enables or disables the RIP interface.
Configures the RIP version used by this interface.
The default value is version 1.
When enabled, the switch accepts RIP default routes from other routers, but gives them
lower priority than configured default gateways. When disabled, the switch rejects RIP
default routes. The default value is disabled.
When enabled, the switch supplies routes to other routers. The default value is disabled.
When enabled, the switch learns routes from other routers. The default value is disabled.
When enabled, the switch uses split horizon with poisoned reverse. When disabled, the
switch uses only split horizon. The default value is disabled.
Enables or disables Triggered Updates. Triggered Updates are used to speed
convergence. When enabled, Triggered Updates force a router to send update messages
immediately, even if it is not yet time for the update message. The default value is
disabled.
Configuring the switch 188