HP GbE2c - Blc Layer 2/3 Fiber SFP Option Interface Manual page 115

The following table describes the Switch Management Processor Configuration (basic) controls:
Table 90 Switch Management Processor Configuration (Basic) controls
Control
Switch IP Address
Switch IP Subnet Mask
Enable/Disable BOOTP for IP Management
Enable/Disable DHCP for Management
Interface
Enable/Disable Console output of syslog
messages
Enable/Disable Host Name
Syslog Host IP Address
Severity of Syslog Host
Facility of Syslog Host
Second Syslog Host IP Address
Severity of Second Syslog Host
Facility of Second Syslog Host
Current Date
Current Time
Login Notice
Banner
Telnet Port (1-65535)
TFTP Port (1-65535)
Idle Timeout (1-60)
Daylight Savings Location
Description
Configures the IP address of the switch interface using dotted decimal notation.
Configures the IP subnet address mask for the interface using dotted decimal
notation.
Enables or disables the use of BOOTP. If you enable BOOTP, the switch will
query its BOOTP server for all of the switch IP parameters. This command is
enabled by default.
Enables or disables Dynamic Host Control Protocol for setting the management
IP address.
Enables or disables delivering syslog messages to the console. When
necessary, disabling console ensures the switch is not affected by syslog
messages. It is enabled by default.
Enables or disables displaying of the host name (system administrator's name)
in the Command Line Interface (CLI).
Sets the IP address of the first syslog host.
This option sets the severity level of the first syslog host displayed. The default
is 7, which means log all the seven severity levels.
This option sets the facility level of the first syslog host displayed. The default is
0.
Sets the IP address of the second syslog host.
This option sets the severity level of the second syslog host displayed. The
default is 7, which means, log all seven severity levels.
This option sets the facility level of the second syslog host displayed. The
default is 0.
Configures the system date.
Configures the system time using a 24-hour clock format.
Displays login notice immediately before the "Enter password:" prompt in the
Command Line Interface (CLI). This notice can contain up to 1024 characters
and new lines.
Configures a login banner of up to 80 characters. When a user or
administrator logs into the switch Command Line Interface (CLI), the login
banner is displayed.
It is also displayed as part of the output from the /info/sys/gen command.
Sets an optional telnet server port number for cases where the server listens for
telnet sessions on a non-standard port. The default is 23.
Sets an optional TFTP server port number for cases where the server listens for
TFTP sessions on a non-standard port. The default is 69.
Sets the idle timeout for CLI sessions, from 1 to 60 minutes. The default is 5
minutes.
Configures the time zone where the switch resides. You are prompted to select
your location (continent, country, region) by the timezone wizard. Once a
region is selected, the switch updates the time to reflect local changes to
Daylight Savings Time, etc.
Configuring the switch 115