Virtual Router Operation; Domain Name System Dashboard - HP GbE2c - Blc Layer 2/3 Fiber SFP Option Interface Manual

Virtual Router Operation

NOTE: This form is available only on the GbE2c Layer 2/3 Ethernet Blade Switch.
To display the following form, go to the Virtual Routers Dashboard. Select a virtual router number.
The following table describes the Virtual Router Operation controls:
Table 42 Virtual Router Operation controls
Control
Set Virtual Router to Backup

Domain Name System Dashboard

To display the following form, select Layer 3 > Domain Name System.
This form summarizes DNS information.
Description
Forces the master virtual router into backup mode. This is generally used for
passing master control back to a preferred switch once the preferred switch
has been returned to service after a failure. When this command is executed,
the current master gives up control and initiates a new election by temporarily
advertising its own priority level as 0 (lowest). After the new election, the
virtual router forced into backup mode by this command will resume master
control in the following cases:
This switch owns the virtual router (the IP addresses of the virtual router
and its IP interface are the same)
This switch's virtual router has a higher priority and preemption is
enabled.
There are no other virtual routers available to take master control.
Dashboard 55