Hard-Drive Cage Hard-Drives; Removing A Hard-Drive Carrier Located On The Sled Cover - Dell PowerEdge C8000 Hardware Owner's Manual

1 screws (4)
3 hot-plug hard-drive carrier
Installing a Hard-Drive Into a Hard-Drive Carrier
CAUTION:
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
1 Place the hard-drive into the hard-drive carrier. See Figure 3-14.
2 Replace the four screws securing the hard-drive to the hard-drive carrier.
See Figure 3-14.

Hard-Drive Cage Hard-Drives

The sled supports a multiple drive bay design that allows installation of up to
eight 2.5-inch hard-drives or four 3.5-inch hard-drives installed into the sled
cover.

Removing a Hard-Drive Carrier Located on the Sled Cover

CAUTION:
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
CAUTION:
have hard-drive blanks installed.
CAUTION:
configuration is not supported.
CAUTION:
the SAS/SATA backplane.
CAUTION:
swappable drive installation. See the documentation supplied with the operating
system.
150
Installing System Components
Many repairs may only be done by a certified service technician. You
Many repairs may only be done by a certified service technician. You
To maintain proper system cooling, all empty hard-drive slots must
Combining SAS, SATA, and SSD hard-drives in the same sled
Use only hard-drives that have been tested and approved for use with
To prevent data loss, ensure that your operating system supports hot-
2 hard-drive