Installing The System Battery - Dell PowerEdge C8000 Hardware Owner's Manual

Installing the System Battery

WARNING:
installed. Replace the battery only with the same or equivalent type recommended
by the manufacturer. See your safety information for additional information.
CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
1 Hold the new battery with the "+" facing the retention clip on the battery
connector. See Figure 3-82.
2 Insert the "-" side of the battery then push the positive side
3 Gently pull the retention clip towards the positive side of the connector
and slide the battery into the connector until the retention clip snaps into
place. See Figure 3-82.
4 Close the sled. See "Installing the Front and Back Sled Covers" on
page 165 or "Installing the Sled Cover" on page 168.
5 Replace the sled. See "Installing a Sled" on page 142.
6 Reconnect the system to the electrical outlet and turn the system on,
including any attached peripherals.
7 Enter the System Setup program to confirm that the battery is operating
properly. See "Using the System Setup Program" on page 55.
8 Enter the correct time and date in the System Setup program's Time and
Date fields.
9 Exit the System Setup program.
There is a danger of a new battery exploding if it is incorrectly
Installing System Components
253